Industrial high efficiency horizontal fire tube steam boiler
Boiler plant equipment as three major important energy conversion device, fuel chemical energy into heat energy, and the pot was heated using thermal energy to become hot water having a sufficient quantity and a mass (steam temperature, steam pressure) steam turbine for use. The Anyang City, the power company to my company to buy a split 2 tons of steam condensing gas industrial high efficiency horizontal fire tube steam boiler for supplying electricity demand. The WNS series split condensing boilers using advanced technology designed to greatly improve the thermal efficiency of the boiler, up to about 96%.
Flue gas condensation in aqueous industrial boilers and industrial boiler flue gas condensing position of the condensation water and the condensed position 1, the industrial high efficiency horizontal fire tube steam boiler flue gas dew point of industrial coagulation process means starts to condense water vapor in the flue gas the temperature, condenses into water vapor when the temperature is lower than the dew point temperature. Without considering the impact of the acid gas, flue gas dew point increases to increase, increasing the concentration of water vapor in the flue gas, increases as the excess air ratio is reduced. Formation of condensation water depends on the temperature distribution of the flow cross-section. For example, when the flue gas through the pipe, the core flow temperature maximum, minimum wall temperature. When the wall temperature is higher than the dew point, no condensate water, when the wall temperature below the dew point temperature of the core flow above the dew point. When the core flow temperature below the dew point, the air flow condensing section. Number of smoke generated condensed water is affected by many factors, such as size, fuel, exhaust gas temperature, the air ratio, the structure of the boiler heat transfer surfaces and the like. 2, boiler condensate condensed gas industry position in the boiler in order to improve the thermal efficiency of the boiler, efficient recovery of the latent heat of the flue gas steam gasification boiler with a condenser and is widely used in industrial heating systems, i.e., by installation absorb latent heat of water vapor in the flue gas. Saving device and a condenser. At design conditions, the flue gas temperature at the outlet of the boiler body above the water vapor dew point temperature, water vapor in the flue gas mainly in the condenser and economizer. Since the high-temperature steam in the boiler, the exhaust gas temperature before the flue gas enters the economizer is generally higher than the dew point, so a small amount of water vapor generated by the boiler condensate, hot water boilers and boiler due to low temperature, return water temperature lower than the annealing furnace smoke gas dew point temperature. Winter start or low load operation, leading to the exhaust gas temperature below the dew point temperature. Thus, prior to entering the economizer, some of the water vapor in the flue gas of the boiler tail heating surface condenses into water. The above analysis, generating the main part of the condensed gas are in industrial boiler economizer heating surface and the boiler, and thus boiler economizer outlet gas industry are usually set in a drain nozzle of the heating surface.
Pharmaceutical enterprises have huge energy consumption, and the use of high-efficiency and energy-saving boilers is conducive to reducing production costs and saving energy. As a leader in the research and development of clean energy high efficiency industrial boilers, CBM is committed to providing clean and efficient boilers for the pharmaceutical industry and contributing to the sustainable development of the pharmaceutical industry.
Because such gas boiler equipment belongs to gas energy, so the cost is relatively low, especially compared with coal-based boiler, in the cost have been reduced, has become among the many companies will attention to the point. Not only that, now the manufacturers, because in the production of technical improvements, so this device, you can have a system of automatic control, added safety protection devices, etc., so when during use, do not worry about the safety of one of the problem.