Steam Generator Thermostat Ksd301
How boilers used in conjunction with other equipment and cleaning instructions: boiler water and fire tube What's the difference? Boiler and steam turbine and generator, how the relationship between the three? As well as, boiler cleaning time, how long it should be a relatively good? These are questions belonging to the boiler area, but also we want to know, so the following, a good answer to it, its details are as follows.
Boiler plant equipment as three major important energy conversion device, fuel chemical energy into heat energy, and the pot was heated using thermal energy to become hot water having a sufficient quantity and a mass (steam temperature, steam pressure) steam turbine for use. The Anyang City, the power company to my company to buy a split 2 tons of steam condensing gas steam boiler for supplying electricity demand. The WNS series split condensing boilers using advanced technology designed to greatly improve the thermal efficiency of the boiler, up to about 96%.
The biomass fuel in Power plant is consumed using a direct-fired process similar to fossil fuel-fired power generating plants, but with lower air emissions. The fuel burns and heats water in a biomass power plant boiler that produces high-pressure steam, which is then piped to a steam turbine where it flows over a series of aerodynamic blades, causing the turbine to rotate. The turbine is connected to an electrical generator that produces the electricity.
9.Steam from the steam drum is sent to the primary super-heater.
10.Steam is super heated to a high temperature and pressure in the primary super-heaters and then moves to the secondary super-heaters.
11.In the secondary super-heaters steam meets the very hot gases exiting the top of the boiler. The steam is heated to its final temperature and pressure before leaving the boiler as main steam. The main steam is sent to the high pressure steam turbine. The steam turbines drive a generator which produces electricity.
12.Steam exiting the high pressure steam turbine is called cold reheat. It is reheated in the re-heater and sent back to the second steam turbine. By the time the flue gas exits the boiler most of the energy in the coal will be transferred to the water in the boiler. The hot gases are cleaned up before they are sent to a stack. Feed-water is generally supplied by condensed steam from the low pressure steam turbine. Large amounts of cooling water are used to condense this steam into liquid water in the condenser.