Such boilers are mainly fueled by natural gas, oil, gas, etc. For customers, the fuel used in such boilers is relatively high in price relative to fuels such as coal and biomass. However, the boiler is easy to use and the fuel is transported by pipeline without storage. Biomass fuels, and fuels such as coal, need to be processed in advance when used in boilers, and because of the large amount of consumption, fuel transportation, and fuel storage are not small expenses. However, the oil and gas water boilers produced by ZG boiler do not need these additional inputs.

The characteristics of internal circulating fluidized bed boiler

The internal circulating fluidized bed boiler (ICFB) efficiently co-combusts industrial waste, biomass fuel and coal, provides steam or hot water, and sets new standards in limiting SOx and NOx generation. In addition to the characteristics of general CFB boiler, the internal CFB boiler also has the following special structure and characteristics:

1. The internal CFB boiler has buried pipes, which can increase the heating area and regulate the temperature in the dense area.

2. The internal CFB boiler has a large area of air distribution bed, so that the boiler has more heat storage, which is conducive to fuel combustion and burnout, and provides a congenital condition for a wider variety of coal adaptability;

3. The internal CFB boiler has a large cross-sectional area of the furnace, the flow rate of flue gas is low, which can improve the primary combustion rate of fuel, reduce the wear of the furnace, reduce the power consumption and energy consumption;

4. The wind arch composed of secondary air can supply oxygen and disturbance on the one hand, and on the other hand, can lengthen the combustion time of coal, which is conducive to coal burnout;

5. Water-cooled membrane wall of the cyclone separator, effectively prevent high temperature coking and center cylinder bias, which improves the efficiency of the separator;

6. Porous and controllable feed return valve makes the feed return reliable, even if the feed return has a coke block, since there are a lot of feed back port, there is no need to immediately stop the furnace, the user can stop the furnace when it is available for them to clear the coke.

7. Tail flue gas duct patented technology: water cooling furnace roof and chevron water cooling flue gas duct, can effectively solve the roof and smoke wall collapse and leakage of ash or air, which improve the environment of the boiler room.

The temperature difference between the wall surface of the vertical steam boiler steam is generated during the vertical steam boiler generates steam, and pressure in the heating, when the temperature is higher than the outer wall temperature of the inner wall, the wall temperature is higher than the temperature of the lower wall, and wall thickness of the vertical bubble there is a temperature difference between the walls, i.e., the inner wall temperature of the bubble is higher than the temperature of the outer wall, the wall temperature is higher than a temperature lower wall, an outer wall and inner wall temperature is higher than the temperature of the inner wall temperature is higher than the outer wall temperature, the wall temperature is higher than the temperature of the lower wall , the wall temperature is higher than the outer wall temperature, the wall temperature is higher than the temperature at the wall, the inner wall temperature is higher than the outer wall temperature. Steam boiler is an energy conversion device, the energy input to the boiler fuel chemical energy, electrical energy, thermal energy and other forms of high temperature flue gas, and after converting the boiler, the steam output having a certain outside thermal energy, high-temperature hot water or an organic carrier. Biomass boiler is a kind of boiler to biomass energy as a boiler fuel called biomass boilers, steam boilers into biomass, biomass low pressure biomass hot water boiler for hotel, biomass stove, biomass thermal oil heaters, vertical raw biomass boilers, biomass boilers and other horizontal. In order to prevent excessive thermal stress, it is necessary to slow the vertical steam boiler booster. Vertical steam boiler ignition and boosting process conditions steam parameters, each component level and also changing. Therefore, in order to effectively prevent the occurrence of abnormal conditions and other hazards, it is necessary to arrange closely monitor vertical steam boiler various instruments directive professionals change. Since the vertical steam boiler water temperature continues to rise, the metal wall temperature of the bubble and the evaporator heating surface begins to rise at any time, it is necessary to pay attention to temperature and thermal stress of thermal expansion of the bubble, since the bubble wall thickness is relatively thick, so vertical the main problem in the steam boiler heating thermal stress. At the same time, also considering the overall thermal expansion problems, especially vertical tube steam boiler heating surface, since the wall thickness, length of problems in the process of heating the whole of the problems of thermal expansion, it should also be noted that the thermal stress. Prevent inadvertent failure caused.

Mr. Liu, a pedestrian to my company's remote monitoring cloud services platform is very interested that this is a powerful combination boiler industry and Internet technology-based platform enables real intelligent control mode boiler, the boiler industry's future development have a very high confidence. The delegation of the aspects of our company continue to promote scientific and technological innovation strength, low nitrogen emission technology upgrade, focusing boiler lifecycle management fully affirmed. Heartfelt praise to our initiative to extend the upstream and downstream industries, and actively challenge higher level field.